Special flexible shafts for inner grinding of pipes BW 4 PST-T DIN 10/M4 1.5 m

flexible shaft BW 4 PST-T DIN10/M4 1.5 metres for POLISTAR-Tube 7,650-1,500 RPM/450-100 watts

Item number:
87101801
EAN:
4007220432341

Login / Register
Technical information
flexible shaft BW 4 PST-T DIN10/M4 1.5 metres for POLISTAR-Tube 7,650-1,500 RPM/450-100 watts

Dia. drive-side coupling [mm]
30
Dia. external
13 mm
Dia. thread
M4
Dia. tool mounting
4 mm
Drive-side coupling, DIN
10
Height
13 mm
Length
1537 mm
Net weight
0.48 kg
PFERD type
BW 4 PST-T DIN 10/M14 1,5 m
Power range, from
100 watts
Rotational speed range, from
1500 RPM
Rotational speed range, to
7650 RPM
Width
13 mm
Packaging unit
1 piece
Description

These special flexible shafts do not have a handpiece for tool mounting and are particularly flexible in the front section. The POLISTAR-TUBE grinding tools are attached directly to the core of the flexible shaft with screws (INOX type). POLINOX cross buffs PNST are screwed on with adapter AD M4 or AD M5 (accessories). This combination is highly suitable for gradual fine grinding and cleaning of inner surfaces of pipes and pipe bends. Both pipe bend ends can be deburred from the entry side.

The PST-T flexible shaft is suitable for grinding the insides of pipes.

The flexible shaft is exclusively for use with POLISTAR-TUBE PST diameter 50, 60, 70 and 80 mm.

Recommendations for use
  • Flexible shaft motors with stepless rotational speed regulation are recommended as tool drives.
  • Before the POLISTAR-TUBE and the shaft are introduced into the pipe, the tool should be preformed and adjusted to the pipe diameter.
  • At the moment of introduction, it is recommended to reduce the respective operating speed of the POLISTAR-TUBE.
  • The grinding of pipes with more than three bends should be performed from both ends whenever possible.
  • When the tool flaps emerge at the end of the pipe, they can be withdrawn while in rotation. This way, the rear side of the POLISTAR-TUBE deburrs the pipe end and at the same time polishes the inside of the tube during the reverse motion.
  • All flexible shaft drives with rotational speed range 7,650–1,500 RPM and flexible shaft connection DIN 10 can be used.
  • For maintenance of the flexible shaft, PFERD recommends the P‐SET BW 4/6 maintenance set.
Ordering notes
  • Special lengths available on request.
Safety notes
  • Observe the recommended and maximum permitted rotational speeds of the tools for the rotational speed setting of the motor.
Downloads

PFERD Newsletter subscription

Register here free of charge for our PFERD newsletter and receive all the latest news on products, services and promotions from the world of PFERD on a regular basis.